80TAC 80 Ton Smart Air Conditioner Rental w/Cooling, Heating & Dehumidification Modes

 80TAC 80 Ton Smart Air Conditioner Rental​:
General 
Value Duct/Hose (2-3) 20” Supply / (4) x 20” Return  
Electrical:
Certification UL Listed components
Single Point Power Supply 460V/3PH/60HZ 
Connections Single point Series 16 Cam-Lok connections
Cooling Amps 147.1 A (460V) 
Heating Amps 214 A
Dehumidification Amps 210.8
Dimensions:
Length (Base) 156” Width 88” Height 99 3/4”
Unit Weight (Estimated) 9,800 Lbs
NOTE: Unit Arrangement - Dimensions are Approximate may change depending upon equipment availability
Unit Features:

• Single 40HP Copeland Scroll Compressor per circuit, 2 total
• Direct drive High Static plenum fan with 25 or 30hp TEFC motor
• Maximum rated static pressure of 6.5 in-wg
• Rated cooling air flow of 12,800 cfm with 100% Outside Air
• Air flow range of 8,000 – 20,000 cfm
• Hydrophilic coated, non-lanced condenser fins
• Hydrophilic coated evaporator fins
• Stainless steel hardware
• Stainless Steel drain pan
• Unit capable of operating between +35°F - 105°F ambient temperatures
• Permanently installed drain pan P-trap (protected within unit base)

Package Features

• Phase monitor and Incorrect phase indicator light (red)
• Circuit Breakers on all motors
• Blower VFD with inline starter and bypass switch
• Speed Potentiometer for Blower VFD to adjust speed from 30Hz to 69Hz
• High and low pressure safety switches
• R-410a refrigerant
• Full tubular rental frame with fork pockets & tie-down points
• Hot-dipped galvanized
• Overhead certified lift frame
• Entering and leaving air temperature sensors
• Unit can run in COOLING/HEATING or DH modes
• Cooling unit may run in HAND (manual) MODE of LOCAL (via PLC control) MODE
• Unit can control off supply or return air temperature via RS/SA switch
• In DH mode both stages of cooling and 1 stage heat may operate simultaneously
• Duct Doors factory installed for all supply/return connections
• Quiet operation
• Integral 144-162 KW electric heating section featuring:
• Stainless steel finned tubular heating elements
• 3-4 independent heating stages
• Independent contactor, hard wired overload, and circuit breaker for each stage

Download 80TAC Specifications Data:

Accessories:
Cabling
#1, 2 & 4 Banded Cam-Lok Feeder Cable Assemblies

Ducting
Industrial Ventilation {Ducting} 12", 14", 16" & 20"